Print settings

This item is displayed when you select Printer settings from Various settings on the HOME screen.

• Prevent paper abrasion

  Use this setting only if the print surface becomes smudged.

  Important

  • Be sure to set this back to OFF after printing since it may result in lower print quality.

• Auto photo fix settings

  Selecting Yes will prioritize the printing of the Exif information in the image.

• Adjust horizontal print position

  Adjusts the print position when the left/right margins are not aligned.

  You can adjust the left/right margins in increments of 0.01 inch/0.1 mm between -0.12 inch/-3 mm and +0.12 inch/+3 mm centered on the horizontal center of the paper.

  Important

  • For A3, A3+ and 12" x 12" (30 x 30 cm), you can adjust the left/right margins between -0.06 in. (-1.5 mm) and +0.06 in. (+1.5 mm) even if you specify the value over 0.06 in. (1.5 mm).

• Magnification level for borderless

  Selects the amount of image that extends off the paper when printing in borderless (full).

  When performing Borderless Printing, slight cropping may occur at the edges since the printed image is enlarged to fill the whole page. You can change the width to be cropped from the borders of the original image as needed.

  Important

  • Settings will become ineffective in the following situations:

    • Printing from a standard form.

  Note

  • When performing settings from application software or the printer driver, these settings will be prioritized.

  • If printouts contain margins even though you are printing in Borderless, specifying Large for this setting may help solve the problem.